I get streaking when applying. What should I do?

Many of the same factors that cause hazing also cause streaking. In our experience, streaking that occurs on application of release is most often the result of contamination, entrapped moisture, or improper application techniques. Presuming that the mold was cleaned properly, how you apply the release can have a big impact. Both sealer and release should be applied in a light even coating, using clean 100% cotton cloths. Do not use synthetic cloths because the solvent in the mold release can dissolve this type of cloth and cause streaking. DO NOT REUSE CLOTHS. 

Shop environment and atmospheric conditions can play a major role in aggravating streaking. Hazing can occur when molds are cooler than air temperatures. This can result in condensation being trapped within the mold release coating as it cures.